Advertisement
Available languages
Available languages
Installation
instructions
F-4-] EXHAUST CONNECTION
iLWARNING
- TO REDUCE THE
RISK OF FIRE OR PERSONAL INJURY:
, This appliance must be exhausted to the outdoors.
Use only 4" rigid metal ducting for the home exhaust
duct.
Use only 4" rigid metal or UL-listed flexible metal
(semi-rigid or foil-type) duct to connect the dryer
to the home exhaust duct. It must be installed
in accordance with the instructions found in
"Connecting The Dryer To House Vent" on page 8 of
this manual.
Do not terminate exhaust in a chimney, a wall,
a ceiling, gas vent, crawl space, attic, under an
enclosed floor, or in any other concealed space of
a building. The accumulated lint could create a fire
hazard.
Never terminate the exhaust into a common duct
with a kitchen exhaust system. A combination of =
grease and lint creates a potential fire hazard.
Do not use duct longer than specified in the exhaust
length table. Longer ducts can accumulate lint,
creating a potential fire hazard.
Never install a screen in or over the exhaust duct. This
will cause lint to accumulate, creating a potential fire
hazard.
Do not assemble ductwork with any fasteners
that extend into the duct. These fasteners can
accumulate lint, creating a potential fire hazard.
Do not obstruct incoming or exhausted air.
Provide an access for inspection and cleaning of
the exhaust system, especially at turns and joints.
Exhaust system shall be inspected and cleaned at
least once a year.
THIS DRYER COMES READY FOR REAR
EXHAUSTING. IF SPACE IS LIMITED, USE
THE INSTRUCTIONS IN SECTION 6 TO
EXHAUST DIRECTLY FROM THE SIDES
OR BOTTOM OF THE CABINET.
STANDARD
REAR EXHAUST
Forstraight line installation, connect
the drger exhaustto the external
exhausthood using duct tape or
clamp.
EXTERNALDUCT
OPENING
DUCTTAPE OR
DUCT CLAIVlp
4" IVlETALDUCT CUT
TO PROPERLENGTH
DUCTTAPE OR
DUCT CLAIVlp
STANDARD REAR EXHAUST
(Vented above floor level}
L
AGE
NOTE: ELBOWS WILL PREVENT DUCT KINKING AND COLLAPSING
ELBOW HIGHLY
RECOMMENDED
[_]LEVELING AND STABILIZING YOUR
APPLIANCE
/
/
_E
LEVEL
-T0-SIDE
FRONT-T0-BACK,
_Z_
2 LEVELING
LEGS
Level and stabilizing
your
appliance
1. Carefully move the appliance to its final location.
Gently rock the appliance into position. It is important
not to damage the rubber leveling legs when mov-
ing your appliance to its final location. Damage legs
can increase appliance vibration. It may be helpful to
spray window cleaner on the floor to help move your
appliance to its final position.
Note: do not use washer cover to lift the unit.
2. To ensure the appliance is level and solid on all four
legs, tilt the appliance forward so the rear legs are off
the ground. Gently set the appliance back down to
allow the rear legs to self adjust.
]. With the appliance in its final position, place a level on
top of back part of the washer lid and check it side to
side, then check front to back. Screw the front leveling
legs up or down to ensure the appliance is resting solid
on all four legs (no rocking or the appliance should ex-
ist), turn the lock nuts on each leg up toward the base
of the unit and snug with a wrench.
Note: Keep the leg extension at minimum to prevent
excessive vibration. The farther out legs are extended, the
more the unit will vibrate.
7
Advertisement
