Switching Lines During Calls - Konftel 300 User Manual

DURinG a call

sWiTcHinG lines DURinG calls

connecting a new line during a call
You can add another line or switch between connected lines during a call.

Press the line MoDe button during the call.
An indicator appears on the display screen in front of the selected line(s).

Use the arrow buttons to mark the line you want to connect and confirm your choice
by pressing
If you selected USB or MOBILE, this line will open. You then connect the call via the computer
or mobile phone.
If you selected ANALOGUE, you will hear a dialling tone. You then dial the number on the
Konftel 300 or use the Phonebook.
Please note that an analogue line and a mobile line cannot be used simultaneously.

If you are using ANALOGUE or ANALOGUE+USB as a line connection and you wish
to connect MOBILE during a call, the ANALOGUE line will be put on hold. This is
indicated by a flashing LED on the display screen.
Putting a line on hold during a call

Press the line MoDe button during the call.
 Use the arrow buttons to mark the line you want to put on hold and press the HolD
button.
The indicator in front of the selected line starts to flash.

Repeat the above to reconnect the line.
Disconnecting a line during a call

Press the line MoDe button during the call.

Use the arrow buttons to mark the line you want to disconnect and confirm your
choice by pressing
The indicator in front of the selected line goes out and the line is disconnected. The other calls
can continue.
12
.
.