Table of Contents
Advertisement
DS=0-19 Dial the dial string associated to the memory location (from 0 to 19) stored using &Z command
Dn1*n2 Dial two number (n1 and n2) for MLPPP at 128Kbps. If the service access at 128Kbps is over a
single telephone number the n1 is egual to n2.
Example: ATD702611*702611
See also the command A%A2 for MLPPP activation
Store: n/a
E
Echo commands ON/OFF
Enable or disable echo of commands from the Computer to Tintoretto.
E0
Command echo disabled
E1
Command echo enabled
Store: S14 (bit 1)
H
Hang up
Hang up the Tintoretto from the ISDN network.
H0
Hang up Tintoretto from the ISDN network (off-line). This command is accepted only in Escape
mode.
Store: n/a
I
Product Information
I0
Model.
I1
Checksum calculation, the result is displayed in Hexadecimal digit.
I2
Compare the checksum calculation with the stored value, the response will be OK or ERROR.
I3
Revision level.
I4
Display Central office
Store:= n/a
N
Select the speed adaptation (V.110 or V120)
N0
In Originate mode: Tintoretto makes the connection at the speed fixed from register S37
In Answer mode: Tintoretto accepts incoming call in accordance with the set-up of the command
AT%A2 and the register S37.
N1
In Originate mode:Tintoretto makes the connection at the speed detected at the last autobaud.
If this value is greater than 19200bit/s, the connection will be established at 19.200bit/s.
For speed detection below 19.200bit/s, the connectionwill be established at the line speed.
In Answer mode:Tintoretto handshake the standard and the speed in accordance with the Bearer
Capability information sent from the remote user
Store: S24 (bit 4)
O
Go On-line from Escape
Tintoretto returns in On-line from the Escape status
O
Go On-line.
Store: n/a
3.7
Description
Default= n/a
Default= E1
Default= n/a
Default= n/a
Default= N1
Default= n/a
Advertisement
Table of Contents
