GE GLDT696T00SS Installation Instructions Manual page 6

Installation Instruction
STEP 2 - ADJUST LEVELING LEGS
.Hove the dishwasher close to the installation
location and lay it on its back.
Adjust to
Installation
Height
Figure 8
,Heasure installation height and dishwasher height.
Extend leveling legs out from the dishwasher base,
1/4"less than installation height.
STEP 3 - REMOVE TOEKICK
.Remove the 2 toekick screws. Lift off the 2 piece
toekick.
' %b-.__
2-Screws-
Figure9
STEP 4 - INSTALL POWER CORD
Skip this step if dishwasher will be direct wired.
The power cord and connections must comply with
the National Electrical Code, Section 422and/or local
codes and ordinances.
Recommended power cord length is 54" min. and 64" max.
A
Remove
Junction Box
Cover _ ',-
.....|- .....z Ground I
D Use UL Listed
B Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Hole in Back
/
Wire Nuts .............../
Figure !0 __..
i ) c
' ' Insert Power
..... ........... Cord Wires Thru
Strain Relief
and Tighten
Connect incoming
power cord white (or ribbed)
to dishwasher white. Black
(or smooth) to black. Ground to dishwasher green
wire. Use UL listed wire nuts of appropriate size.
Replace junction box cover. Be sure wires are not
pinched under the cover.
STEP 5 - INSTALL 90 ° ELBOW
Wrap 90 elbow with thread seal tape.
Install a 90 elbow onto the water valve.
Fill
Hose
90 °
Elbow
Thread
Figure 11 Seal Tape
Water
Valve
Bracket
.Do not over Tighten 90 ° elbow, water valve bracket
could bend or water valve fitting could break.
.Position the end of the elbow to face the rear of the
dishwasher.
6