Advertisement
5.
Use the CURSOR PAD • or • to select
"Other" from brand name choices.
6.
Use the CURSOR PAD • or • to highlight
"Learning Mode" then press the SELECT
button.
10.
If the IR code transfer was successful,
the
screen below appears, then select "OK" to
continue setup.
7.
Use the CURSOR PAD •, •, • and • to
select the Soft Key to learn (Ex. VOL •), then
press the SELECT button.
11.
Select another Soft Key to learn or select
DONE to move on to the next screen.
8.
Press and hold the VOL • button of your A/V
Receiver remote control while pointing directly
at the learning AV NET sensor of the Plasma
TV (located at the lower right corner of the
screen) at a distance of 5 to 10 feet or 2 to 3
meters.
12.
Select the Test button VOL • to check the
response of the device to this command.
13.
Use the CURSOR PAD •, •, • and • to
highlight NEXT, then press the SELECT button
to move on to the next SETUP screen.
9.
If the IR code transfer was not completed,
the
screen below appears.
Repeat step 8 to try
again.
14.
Use the CURSOR PAD • or • to select the TV
Input that connects to the video and audio
output of the A/V Receiver.
15.
Use the CURSOR PAD •, •, • and • to
highlight NEXT, then press the SELECT button
to move on to the next SETUP screen.
86
Advertisement
