Advertisement
Operating
the
precoded
function
for your
Audio
component.
This remote is designed
to operate
different
types of
Audio component.
You must first program
the remote
to match the remote
system of your Audio component
(refer to pages 41-42 for pre-codes).
1.
Turn ©N your Audio component
you wish to control
with the Remote.
2.
Aim the remote control
at the front of your Audio
component.
To switch
to Audio
(AMP) component
pre-coded
mode,
use the SOURCE
ACCESS
buttons
(_1 or I_)
on the remote control
to position
the LED light to
the corresponding
selection.
Hold down the ENT button
on the remote and enter
the four digit preset code that matches
your Audio
component,
as shown on pages 41-42.
Release
the ENT button.
The indicator
light will flash 3
times if the code was accepted.
Aim the remote at the Audio component
and press
the ROWER button.
The remote will turn off your
Audio component
when the correct
four digit
preset code is entered.
When this occurs,
the
remote control
is programmed
for your Audio
component.
If the Audio component
does not turn
off, try a different
four digit preset code.
6.
The remote will now control your Audio
component.
7.
Repeat steps 1 - 6 if you wish to program
the
remote to control another
Audio component.
(b--
@--
TV
DVD
CBL
STB
PVR
AMP
©
0
©
©
0
@
SOURCE ACCESS
I _0L
CN/
I
_
PAGE
_ _us_To
(Puml F OB
HiTACHi
--@
--@
MY AUDIO
COMPONENT
CODE
IS:
(_)
PRECODED
AUDIO
Buttons
These buttons
transmit
the chosen
precoded
Audio
component
codes.
(_)
EXCLUSIVE
TV Buttons
These buttons
are for operating
the TV.
39
Advertisement
