Setup The Treadmill; Getting Started; Making A Choice Of Site; Stabilizing The Treadmill - Vision Fitness T60 Owner's Manual

T R E A D M I L L T 6 0
• Never mount or dismount the treadmill while the running belt is moving.
• Handrails may be held to enhance stability as needed, but are not for continuous use.
• Do not wear any clothing that might catch on any moving parts of this treadmill.
• Never walk or jog backwards on the treadmill.
• Do not use this product in bare feet. Do not use shoes with heels, leather soles, cleats or
spikes. Make sure no stones are embedded in the soles.
• Do not turn the belt by hand.
• Close supervision is necessary when used near children, invalids or disabled people.
• When the treadmill is in use, young children and pets should be kept at least 3 meters / 10
feet away.
305 mm
1000 mm 1000 mm
2000 mm
NOTE:
Orange strip or white strip in the lateral position of
side rail as a criterion to check the belt is in proper
position or not, it is necessary to adjust the belt until
the edge of belt is parallel to orange strip.
WARNING:
"WARNING! Heart rate monitoring systems may be
inaccurate. Over exercising may result in serious
injury or death. If you feel faint stop exercising
immediately".
CAUTION:
Please leave a 2000 x 1000 mm landing zone
behind the treadmill.
04

SETUP THE TREADMILL

GETTING STARTED

Read the Owner's Manual before setting up the T60. Place the treadmill where it will be used
before beginning the setup procedure.

MAKING A CHOICE OF SITE

The site that you select for the treadmill should be well-lit and well-ventilated. Locate the
T60 on a structurally solid and flat surface a few meters / feet from the wall or any equipment
(Allow a distance of 305 millimeter or twelve inches, between the treadmill and other
units on either side. Allow a distance of two meters, or six feet, from the rear of the tread-
mill to any object or surface.) If the site has a heavy plush carpet, to protect the carpeting
and machinery, you should place a rigid plastic base under the treadmill.
Please do not place the treadmill in an area of high humidity, such as the vicinity of a
steam room, indoor pool, or sauna. Exposure to intensive water vapor or chlorine could
adversely affect the electronics, as well as other parts of the machine. To make exercise a
desirable daily activity for you, the treadmill should be in an attractive setting.

STABILIZING THE TREADMILL

After positioning the treadmill in its intended location, check its stability by attempting to
rock it side to side. Rocking or wobbling indicates that your treadmill needs to be leveled.
Determine which leveler is not resting completely on the floor. Loosen the nut with a
hand to allow the leveler to rotate. Rotate the left or right leveler, and repeat the adjustment
as necessary until the treadmill is stable. Lock the adjustment by tightening the nut
against the rear foot support.against the rear foot support.
NOTE: It is extremely important that the levelers are correctly adjusted for proper operation. An
unbalanced unit may cause striding belt misalignment. A bubble level is recommended to
ensure proper leveling.
T R E A D M I L L T 6 0
05