Kenmore 630.1395 Installation Manual page 6

Note: Plumbing installations will vary - refer to local codes.
Drain hose included is 92" (234 cm) and can be extended to
a maximum of 150" (381 cm). Ensure a portion of the drain
hose is raised at least 20" (51 cm) above the floor.
Ensure that the dishwasher electrical installation is in
compliance with all national and local electrical codes and
ordinances. The dishwasher is designed for an electrical
supply of 120V, 60 Hz, AC, connected to a dishwasher-
dedicated, properly grounded electrical circuit with a fuse
Note: Plumbing installations will vary - refer to local codes, or breaker rated for 15 amps. Electrical supply conductors
Drain hose included is 92" (234 cm) and can be extended to shall be a minimum #14 AWG copper only wire rated at
a maximum of 150" (381 cm). Ensure a portion of the drain 75°C (167°F) or higher.
hose is raised at least 20" (51 cm) above the floor.
• A hot water supply line - Minimum 3/8" O.D. Copper
tubing, PEX, or metal braided dishwasher supply line.
• 120°F (49°C) water at dishwasher.
• Shut-off valve and fittings appropriate for hot water
supply line (copper tubing/compression fitting or
braided hose).
• 90 ° elbow with 3/8" N.P.T. male threads on one leg,
and sized to fit your water supply line (copper tubing/
compression fitting, or braided hose) on the other leg.