Supero SUPERSERVER 5026T-3F User Manual page 66

S S
UPER ERVER 5026T-3F/5026T-T Manual
Installing/Removing SAS/SATA Drives
The SAS/SATA drive bays are located in the front of the chassis and are hot-swap
units, meaning that they can be installed and removed while the system is run-
ning.
1. To remove a SAS/SATA drive, fi rst push the colored release button located
beside the drive's LEDs.
2. Swing the handle fully out and use it to pull the drive carrier straight out (see
Figure 6-4).
Release Button
Figure 6-4. Removing SAS/SATA Drives
Important: All of the SAS/SATA drive carriers must remain in the
!
drive bay to maintain proper cooling airfl ow.
6-6