Jenn-Air JJW3430 Installation Instructions Manual page 3

Cabinet Dimensions Minimum Installation Clearances
27" (68.6 cm) and 30" (76.2 cm) Microwave Ovens
F
E
IIII
I
B
C
27" (68.6 cm) models
A. 27" (68.6 cm) min. cabinet
width
B. 19¼" (48.9 cm) from bottom of
cutout to bottom of upper
cabinet door
C. 4G' (101.6 cm) bottom of
cutout to floor (recommended)
D. 25½" (64.8 cm) cutout width
E. 1 ½" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 18¼" (46.4 cm) recommended
cutout height (will fit cutout
height from 17" [43.2 cm] to
18¼" [46.4 cm])
G. 21 _" (55.5 cm) min. cutout
depth
30" (76.2 cm) models
A. 30" (76.2 cm) min. cabinet
width
B. 19¼" (48.9 cm) from bottom of
cutout to bottom of upper
cabinet door
C. 40" (101.6 cm) bottom of
cutout to floor (recommended)
D. 28½" (72.4 cm) cutout width
E. 1 ½" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 18¼" (46.4 cm) recommended
cutout height (will fit cutout
height from 17" [43.2 cm] to
18_" [46.4 cm])
G. 21 _" (55.5 cm) min. cutout
depth
NOTE:
A microwave oven spacer kit is available from your dealer that will
allow the microwave oven to be installed in an 181¼ '' (46.4 cm) to
197/le'' (49.4 cm) maximum cutout height. Match the color and
size to the following kits:
Microwave Oven Spacer Kit
27" (68.6 cm) Black - Model JMCSK27WB
27" (68.6 cm) Stainless Steel - Model JMCSK27WS
30" (76.2 cm) Black - Model JMCSK30WB
30" (76.2 cm) Stainless Steel - Model JMCSK30WS
To order, see the "Assistance or Service" section of the Use and
Care Guide.
For proper installation the following minimum clearances must
exist above and below the cabinet opening.
1 "
2.5 cm)
A. Upper cabinet
B. Lower single oven*
*Approved models: JJW3430, JJW2430, JJW2427, JJW2330,
JJW2327
E ¸ _ _:_I_,_,_ / i'¸ _'
GROUNDING iNSTRUCTiONS
For a permanently connected microwave oven:
The microwave oven must be connected to a grounded,
metallic, permanent wiring system, or an equipment
grounding conductor should be run with the circuit
conductors and connected to the equipment grounding
terminal or lead on the microwave oven.
SAVE THESE iNSTRUCTiONS
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrical installer determine that
the ground path and wire gauge are in accordance with local
codes.
Check with a qualified electrical installer if you are not sure the
microwave oven is properly grounded.
This microwave oven must be connected to a grounded metal,
permanent wiring system.
Be sure that the electrical connection and wire size are adequate
and in conformance with the National Electrical Code, ANSI/
NFPA 70-latest edition or CSA Standards C22.1-94, Canadian
Electrical Code, Part 1 and C22.2 No. O-M91-1atest edition, and
all local codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
One Batterymarch Park
Quincy, MA 02269
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575