Product Dimensions; Electrical Requirements - Jenn-Air JBS7524BS0 Installation Instructions Manual

24" (59.5 cm) steam and convection built-in oven
Table of Contents

Advertisement

Available languages

Available languages

Cutout Top View
l
26!/4.
(66.7 crn)
19%"
_9.7 cm)
A. Oven
B. Non-flush receptacle
C. Flush receptacle
D. Non-flush receptacle located in upper
right or upper left corner
E. Oven door fully open
A. 18" (45.5 cm)
B. 3_/' (0.4cm)
C. Model/serial rating plate (located on the oven frame
behind the bottom left side of the oven door)
D. 23 ½" (59.5
cm)
E. 13½" (34.2 cm)
F. 21
z_,, (55.5
cm)
G. 3 _"
(9.5cm)
H. 14_" (35.6 cm)
I. 175_ '' (44.7
cm)
J. 19_" (49.7 cm)
K. 22¼"
(51.7
cm)
*Measurements
include front facing of oven. Depth measurement
also includes door handle.
Electrical
Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
IMPORTANT: The range must be electrically grounded in
accordance with local codes and ordinances, or in the absence of
local codes, with the National Electrical Code, ANSI/NFPA 70 or
Canadian Electrical Code, CSA C22.1.
If codes permit and a separate ground wire is used, it is
recommended
that a qualified electrical installer determine that
the ground path is adequate.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch
Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is
required. A time-delay fuse or circuit breaker is also
recommended.
It is recommended
that a separate circuit
serving only this range be provided.
Check that the outlet provides 120-volt power and is correctly
grounded.
The wiring diagram is located on the back of the oven in a
clear plastic bag.
NOTE: The metal chassis of the oven must be grounded in order
for the control panel to work. If the metal chassis of the oven is
not grounded, no keypads will operate. Check with a qualified
electrician if you are in doubt as to whether the metal chassis of
the oven is grounded.

Advertisement

Table of Contents
loading

Table of Contents