Kenmore 79036693507 Installation Instructions Manual page 9

If Accessories Needed :
Installation For 29" Existing Cutout Width Opening
1. You must replace the actual side trims by new and
smaller side trims. These new side panels can be
ordered through a Sears Service Center.
2. Follow instructions supplied with your new side trim_
to replace the actual side trims with the new ones.
3. Check if the countertop is prepared for 29" cutout
wide opening at page 7.
4. Install range as in the "installation Without Side
Panels" section above.
installation With Backguard
A backguard kit can be ordered through a Sears Service
Center.The cutout depth (21 3/4" (55.2 cm) Min.,
22 I/8" (56.2 era) Max.) needs to be increased to24"
(61 cm) when installing a backguard
Installation With End Panel
An end panel kit can be ordered through a Sears Servio
Center.
Installation With Side Panel
A side panels kit can be ordered through a Sears Servio
Center.
Install cabinet doors 31 " (78.7 cm) rain. apart so as not
to interfere with range door opening.
Leveling the Range
ModeJs Equipped with Leveling Device
Level the range after installation in the cutout
opening.
I. Open the range drawer. The leveling screws
control the height of the rear leg.
2. Adjust the appliance legs as follows until the
underside of the cooktop (or cooktop glass)
surface is sitting level on the countertop
(Figure 8).
a.To adjust the front legs, use a wrench on
the leg base and turn counterclockwise to
lower or clockwise to raise the range.
b.To adjust the rear legs, use a ratchet or a
nutdriver and turn the leveling screws
counterclockwise to lower or clockwise to
raise the range.
3. Check if the range is level by installing an
oven rack in the center of the oven and
placing a level on the rack (Figure 9).
4. Take 2 readings with the level placed
diagonally in one direction and then the other.
Level the range, if necessary, by adjusting the
leveling legs.
5. If the range cannot be level, contact a
carpenter to correct sagging or sloping floor.
Models Equipped with Leveling Leg_s
Level the range and set cooktop height before
installation in the cut-out opening.
I. Install an oven rack in the center of the oven.
2. Place a level on the rack (see Figure 9). Take 2
readings with the level placed diagonally in one
direction and then the other. Level the range, if
necessary, by adjusting the 4 leg levelers with a
wrench (see Figure 18).
3. Taking care to not damage the countertop, slide
range into cutout opening and double check for
levelness.
Jst Rear Levelim
Leveling
Font
Leveling
Leg
LOWER
RAISE
Figure 8
J @
Figure 9