Impex MARCY MWM-980 Owner's Manual page 18

STEP 7 (See Diagram 7 & Cable Loop Diagram)
A.) Attach the 116" Upper Cable (#48) to the front opening on the Upper Frame.
NOTE: The Ball Stopper on the Cable needs to be underneath the Frame.
B.) Attach a Pulley (#42) to the opening. Secure it with one M10 x 2 ¾" Allen Bolt
(#56), two Ø 7/8" Pulley Bushings (#43) pre-installed on Upper Frame, and one
M10 Aircraft Nut (#69).
C.) Draw the Cable towards the back of the machine to the second opening on the
Upper Frame. Repeat Procedure B above to install a Pulley.
D.) Draw the Cable around the Pulley then pull back to the open bracket on the Front
Press Base (#8).
E.) Attach a Pulley to the bracket. Secure it with one M1 x ¾" Allen Bolt (#59), two Ø
¾" Washers (#65), and one M10 Aircraft Nut (#69).
F.) Draw the Cable around the Pulley then through the opening on the Vertical Frame
(#2) to the open bracket on the back of Vertical Frame. Repeat Procedure E to
install a Pulley.
G.) Draw the Cable over the Pulley and pull the Cable downwards. Attach a Pulley to
the upper hole on the two Double Floating Pulley Brackets (#30). Repeat Step E
above to install another Pulley with a Cable Retainer (#74). Let the Bracket
hanging for now.
H.) Draw the Cable around the Pulley then pull upwards the third opening on the
Upper Frame. Repeat Procedure B to install a Pulley.
I.) Draw the Cable to the rear opening on Upper Frame. Repeat Procedure B to
install a Pulley.
J.) Draw the Cable downwards between the two Guide Rods (#17) to the Selector
Rod (#19). Securely thread the bolt on the end of the Cable into the Selector Rod.
17