Health Airflow Operation - Haier HSU-09RC03/R2(DB) Operation Manual

Operation

Health airflow Operation

1.Press ON/OFF to starting
The liquid crystal will display the working state of last ti
(Except timer, sleeping, power/soft and health airflow).
Setting the comfort work conditions.
2.The setting of health airflow function
1).Press the button of health airflow,
display. The nether inlet and outlet grills of the air condi
are closed and the airflow is blown horizontally from the ab
inlet and outlet grills. Avoid the strong airflow blows dire
the body.
2).Press the button of health airflow again,
the display. The above inlet and outlet grills of the air co
are closed and the airflow is blown vertically from the neth
inlet and outlet grills. Avoid the strong airflow blows dire
the body.
3.The cancel of the health airflow function
Press the button of health airflow again, both the inlet and
outlet grills of the air conditioner are opened, and the uni
on working under the condition before the setting of health
airflow function.
After stopping, the outlet grille will close automatically.
Notice: Cannot pull direct the outlet grille by hand. Otherw
the grille will run incorrectly. If the grille is not run co
for a minute and then start, adjusting by remote controller.
Note:
1 .After setting the health airflow function, the position o
and outlet grills is fixed.
2.In heating, it is better to select the
3.In cooling, it is better to select the
4.In cooling and dry, using the air conditioner for a long t
under the high air humidity, a phenomenon falling drips of
water occurs at the outlet grille .
5.Select the appropriate fan direction according to the actu
conditions.
19
appears on the
appears
mode.
mode.