Operation; Before You Begin; Verify The Insert Is Plugged In; Synchronize The Transmitter To The Receiver - Travis Industries DVS GSR Owner's Manual

28

Before You Begin

•
Read this entire manual before you use your new heater (especially the section "Safety Precautions"
on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or
even death.
Remote Set-Up

Verify the Insert is plugged in

The insert should be plugged in before synchronizing the remote.

Synchronize the Transmitter to the Receiver

The transmitter will need to be synchronized to the receiver before the remote will work correctly.
Synchronizing is done in the following two steps below (see Figure 1):
a) Press the PRG (Program) button on the receiver using a paperclip or equivalent device (receiver
will beep 3 times).
b) Press the "ON" button on the transmitter (receiver will beep 4 times).
NOTE: If power is cut off to the receiver for an extended period of time, you may need to re-synchronize
the remote.
© Travis Industries

Operation

"Beep"
"Beep"
"Beep"
4100105
"Beep"
"Beep"
"Beep"
"Beep"
Figure 1
100-01245_000