Attaching And Removing The Seat; Attaching The Leg Lever To The Low Pulley Station; Adjusting The Leg Press Plate; Locking The Weight Stack - Weider Pro 9450 User Manual

ATTACHING AND REMOVING THE SEAT

42 8
40
To attach the Seat (13), slide one of the three slots in
36
the bracket on the Front Seat Frame (36) onto the pin
13
on the Front Upright (42). (Note: The Seat can be
attached at three different heights.) Secure the
14
Front Seat Frame to the Front Upright with the 5/16" x
2 3/4" Carriage Bolt (14), a 5/16" Washer (8), and the
Seat Knob (40).
Pin
For some exercises, the Seat (13) must be removed.
First, be sure that the chain is not attached to the leg
lever. Remove the Seat Knob (40), the 5/16" Washer
(8), and the 5/16" x 2 3/4" Carriage Bolt (14), and lift
the Front Seat Frame off the Front Upright (42).
ATTACHING THE LEG LEVER TO THE LOW
PULLEY STATION
To use the Leg Lever (29), the seat must be attached
29
to the front upright (see ATTACHING AND REMOV-
53
ING THE SEAT above). 52
35
Attach one end of the Chain (52) to the Low Cable
(23) with a Cable Clip (53). Attach the other end of
53
the Chain to the 3/8" x 2" Eyebolt (35) with a Cable
Clip.
23

ADJUSTING THE LEG PRESS PLATE

Remove the Press Pin (97) from the Leg Press Plate
(95) and the Leg Press Arm (96).
95
Welded
Tube
Align the welded tubes on the Leg Press Plate (95)
with the desired set of holes in the Leg Press Arm
(96). Re-insert the Press Pin (97) through the welded
tubes on Leg Press Plate and the holes in the Leg
97
Press Arm.
96

LOCKING THE WEIGHT STACK

62
73
To prevent unauthorised use of the home gym sys-
tem, insert the Locking Pin (104) into the indicated
hole in one of the Weight Guides (62 or 73) and
secure the Locking Pin with the Lock (105).
Hole
Remove the Locking Pin (104) before using the
weight system again.
105
104
22