Diamondback 510Ub Owner's Manual page 31

Overview The two (2) Fat Burn programs are designed to maintain a relatively low level of exertion over the course of the workout.
Keeping the heart rate at the lower range encourages weight loss.
Selecting From the Idle mode, press the FAT BURN key on the console. Use the UP and DOWN arrow keys to view the available course
profiles, followed by the ENTER key to select the displayed profile.
Classic Programs Setup Mode
Once a Classic Program has been selected, on‐screen messaging will guide the user throughout the Setup Mode.
press the GO key at any time during the Setup mode to skip the setup and begin the workout
NOTE: The user may
immediately the with previously‐saved
selected profile are correct for the current use.
User Selection
"User 1" or the previously‐entered User 1 name value will scroll in the Matrix Display. Use the UP and DOWN arrow keys to view the user
selection options ("User 1", "User 2", "Guest"). When the desired user profile is displayed, press the ENTER key to select. Guest user will run
with default data and will not operate all functions of the heart rate programming.
If the User Setup steps for the selected profile has not been completed, the console will launch the User Setup mode (see the section titled
User Setup Mode for more information), otherwise, the program will launch immediately.
Classic Programs Launch Mode
Once the Classic program has launched:

The Matrix Display will post the workout profile and the current progress in the program will be indicated by a flashing stack of
segments. The height of the stacks represents the level of resistance; the higher the stack, the greater the resistance. The resistance
may be adjusted manually via the UP and DOWN arrow keys.

The Level display will indicate the current resistance level. The range is from 1 to 16.

Total Time field will display the progress made in the total workout. Segment Time will display the progress made in the current
segment. The displays will switch between elapsed and remaining time. Elapsed time will count up, while remaining time will count
down. To freeze the switching and display only elapsed or remaining time, press the RIGHT arrow key while the desired display is
visible. Press the RIGHT arrow key again to resume switching mode.

The Watts field will display the current output or work being generated by the user.

Total Distance for the current workout session will be displayed.
default values. Note that the heart rate feedback will only be accurate if values for the
510Ub Owner's Manual
31