Weslo Pursuit 350 Bike User Manual page 6

6. While another person holds the Upright (13) near the
Frame (1) as shown, connect the Extension
Wire (52) to the Reed Switch Wire (43). Next, con-
nect the Resistance Cable (19) to the Lower
Cable (45) in the following way:
• See drawing A. Pull up on the metal bracket on
the Lower Cable (45), and insert the tip of the
Resistance Cable (19) into the wire clip inside of
the metal bracket as shown.
• See drawing B. Firmly pull the Resistance Cable
(19) upward and slide it into the top of the metal
bracket as shown.
• See drawing C. Using pliers, squeeze the prongs
on the upper end of the metal bracket together.
Push the Wires (52, 43) and the Cables (19, 45)
downward into the Frame (1).
Next, insert the Upright (13) into the Frame (1). Be
careful to avoid pinching the wires and cables.
Attach the Upright to the Frame with three
M8 x 20mm Button Screws (34) and three M8 Split
Washers (42).
7. The Console (16) requires four "AA" batteries (not
included); alkaline batteries are recommended.
Press the tab on the battery cover and remove it.
Insert four batteries into the Console as shown.
Make sure that the batteries are oriented as
shown by the diagram on the battery cover.
Then, reattach the battery cover.
6
13
52
19
43
45
42
34
1
A
Metal
Bracket
19
45
7
6
Be careful to
avoid pinching
the wires and
cables.
42
34
B C
Metal
19
Bracket
45
Battery
Cover
Batteries
16