Yamaha WOLVERINE YFM45FXX Owner's Manual page 47

Table of Contents

Advertisement

3. Shift the drive select lever into the neutral or
park position. The corresponding indicator
light should come on, if it does not come on,
have a Yamaha dealer check the electrical cir-
cuit.
NOTE:
The engine can be started under the following con-
ditions:
G
The drive select lever is in the neutral or park po-
sition.
G
The rear brake lever is applied with the drive se-
lect lever in any position. However, it is recom-
mended to shift into the neutral or park position
before starting the engine.
4. Use the starter (choke) in reference to the fig-
ure:
Position (1):
Cold engine start with ambient temperature
below 5 °C (40 °F).
Position (2):
Cold engine start with ambient temperature
between 0 °C (30 °F) and 30 °C (90 °F).
Position (3):
Cold engine start with ambient temperature
above 25 °C (80 °F).
Ambient temp./starter (choke) position
1. Fully open
2. Half open
3. Closed
4. Starter (choke)
5. Apply the rear brake lever.
6. Completely close the throttle lever and start
the engine by pushing the start switch.
NOTE:
If the engine fails to start, release the start switch,
then push it again. Pause a few seconds before
the next attempt. Each cranking should be as short
as possible to preserve battery energy. Do not
crank the engine more than 10 seconds on each
attempt.
6-2
6

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wolverine yfm45fxwWolverine 450Wolverine 450 yfm45fxx

Table of Contents