Removing The Coin-Cell Battery; Prerequisites - Dell XPS 13 Owner's Manual

Removing the Coin-Cell Battery

WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before Working Inside
Your Computer" on page 7. After working inside your computer, follow the
instructions in "After Working Inside Your Computer" on page 9.
For more safety best practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
WARNING: The battery may explode if installed incorrectly. Replace the battery
only with the same or equivalent type. Discard used batteries according to the
manufacturer's instructions.
CAUTION: Removing the coin-cell battery resets the BIOS settings to default.
It is recommended that you note the BIOS settings before removing the
coin-cell battery.

Prerequisites

1 Remove the base cover. See "Removing the Base Cover" on page 10.
2 Disconnect the power-light board cable from the system board. See "Removing the
Power-Light Board" on page 12.
3 Remove the battery. See "Removing the Battery" on page 14.
4 Remove the wireless card. See "Removing the Wireless Card" on page 19.
5 Remove the solid-state drive. See "Removing the Solid-State Drive" on page 21.
6
Remove the heat sink. See "Removing the Heat Sink" on page 24.
7 Remove the fan. See "Removing the Fan" on page 26.
8 Remove the system board. See "Removing the System Board" on page 34.
38
| Removing the Coin-Cell Battery