Getting Started - Swann 16CH User Manual

2.1 GETTING STARTED

2.1 GETTING STARTED
Connecting all the devices to construct a surveillance.
1) Install HDD:
The HDD must be installed
before the DVR is turned on.
2) Connect cameras.
3) Connect monitors.
4) Connect the external devices.
5) Connect the AC power cord to power adapter and plug into an electrical outlet.
The standby LED would be on as red.
Press the "POWER" button. The power LED will be on as red.
It takes approximately 10 to 15 seconds to boot the system.
Take 16CH as an example
Take 16CH as an example
System Time
GETTING STARTED
GETTING STARTED
NOTE: NOTE:
Please refer to Appendix #1 for HDD installation
instructions.
NOTE: NOTE:
Please refer to "Section 1.5 Rear Panel"
for connection.
NOTE: NOTE:
Please refer to Appendix#2 for pin configurations
of the external I/O port .
Available Capacity of
Internal HDDs
Under HDD Overwrite
Channel Title
10
Mode