Directed Electronics 791XV Owner's Manual page 43

r r a a p p i i d d r r e e s s u u m m e e l l o o g g i i c c
This Directed system will store its current state to non-volatile
memory. If power is lost and then reconnected the system will
recall the stored state from memory. This means if the unit is in
Valet Mode and the battery is disconnected for any reason, such
®
as servicing the car, when the battery is reconnected the unit will
still be in Valet
including arm, disarm, and Valet
p p o o w w e e r r s s a a v v e e r r m m o o d d e e
Your system will automatically enter Power Saver Mode while
armed or in Valet
operation has been performed. This lowers the current draw on
the vehicle's battery. Power Saver Mode takes over under the
following conditions:
➤
Power Saver when the system is armed: After the system has
been armed for 24 hours the LED will flash at half its
normal rate, decreasing the system's current draw.
➤
Power Saver in Valet
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a one hour period while the
system is in Valet
system remains in Valet
the next time the ignition is turned on and then back off.
40
Mode. This applies to all states of the system
®
® Mode.
Mode, after a period of time in which no
®
® Mode: When the system enters Valet
Mode, the LED will shut off. If the
®
Mode, the LED will come back on
®
© 2005 directed electronics, inc.
®