Wan Settings - Pppoe - EnGenius 11b/g Wireless SOHO Router User Manual

11b/g Wireless SOHO Router Version 1.0
Enable IPsec pass through on VPN connection: Place a check in this box to
enable the pass through of L2TP packets on a VPN connection.
Click on the Apply Change to save the changes.
3.3.5 WAN Settings – PPPoE
Click on the WAN link on the navigation drop-down menu. This feature allows you to
configure the WAN interface using a static IP address, DHCP Client, PPoE, or PPTP.
A PPPoE service requires a user name and password to log into the Internet and is
usually a DSL service.
WAN Access Type: Select PPPoE from the drop-down list. This type of connection
is usually used for a DSL service and requires a username and password to connect.
User Name: Specify the user name which is provided by your ISP.
Password: Specify the password which is provided by your ISP.
Service Name: Specify the name of the ISP.
Connection Type: Select Continuous (always online), Connect on Demand
(connect to the ISP only when you click on a website), or Manual (connect to the ISP
only when you click on a 'Connect' button) from the drop-down list.
Idle Time: The PPPoE service can automatically disconnect if the connection is idle.
Specify the number of minutes after between 1 and 100.
DNS: A PPoE service usually automatically assigns the DNS IP address, in case you
need to assign it manually then click on the Set DNS Manually and fill in the fields.
MTU: You may adjust the Maximum Transmit Unit (MTU), however it is recommend
that this value is set to the default: 1500 bytes
DNS 1-3: Specify the IP address of the DNS server
24