Foxconn A88GMV Series User Manual page 21

!
We recommend you using an 8-pin ATX 12V power supply. If
you are using a 4-pin power supply, you need to align the ATX
power connector according to the picture on the right.
front Panel Connector : fP1
This motherboard includes one connector for connecting
the front panel switch and LED Indicators.
Hard Disk leD Connector (HDD-leD)
Connect to the chassis front panel IDE indicator LED.
It indicates the active status of the hard disks. This
2-pin connector is directional with +/- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on the front
panel of the case; the system will restart when the
switch is pressed.
Power leD Connector (PWR-leD)
Connect to the power LED indicator on the front panel
of the chassis. The Power LED indicates the system's
status. When the system is in operation (S0 status),
the LED is on. When the system gets into sleep mode
(S1) , the LED is blinking; When the system is in S3/S4
sleep state or power off mode (S5), the LED is off. This
2-pin connector is directional with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front panel of
the chassis. Push this switch allows the system to be
turned on and off rather than using the power supply
button.
Serial ATA Connectors : SATA_1/2/3/4/5, e_
SATA
The Serial ATA connector is used to connect with SATA
Hard Disk or CD devices which support this feature. The
current Serial ATA II interface allows up to 300MB/s data
transfer rate.
HDD-LED
RESET-SW
SATA_1/2/3/4/5
14
Connect a 4-pin
power plug
1 2
+ +
PWR-LED
-
-
PWR-SW
EMPTY
NC
9 10
FP1
1 1
GND
GND
TX+ TX+
TX-
TX-
GND
GND
RX-
RX-
RX+ RX+
GND GND
E_SATA