Table of Contents
Advertisement
Change the Application Setting —Motion Detection.
Please follow the steps below to enable changes in the motion detection function of the alarm
through the network as necessary.
Set the motion detection:
1.
Click on the Motion Detection button on the left side of the Alarm to enter the "Motion
Detection" page.
2.
Click and drag the mouse across a targeted zone to draw a red rectangle on the image
(coordinates provided below).
NOTE: You can set more than one targeted zone depending on your requirement.
3.
Enables / disables the motion detection function.
4.
Set up the signal level.
5.
Click on the Submit button to submit the new setting of the recording.
6.
Click on the Home button to return to the home page.
Description of function keys:
Sensitivity:
The sensitivity bar allows you to specify how much movement is required to
trigger the motion detection.
Percentage:
Adjusting the percentage allows you to set a requirement on how much of the
motion window must be filled by movement. Example: If you set this to 50%,
then the selected window must be half filled by a moving object before it
triggers motion detection.
60
Hide quick links:
Advertisement
Table of Contents
