Connecting Instructions; Leak Testing - Charmglow Drop-In Side Burner Owner's Manual

• FOR OUTDOOR USE ONLY. DO NOT operate indoors or in an enclosed area such as a garage,
shed or breezeway.
• Use your side burner OUTDOORS in a well ventilated space away from dwellings or other
buildings to prevent dangers associated with gas accumulation and toxic vapors. We recommend
your grill be situated at least 10 feet (3.1 m) from buildings.
• Maintain a minimum clearance of 36 inches (91 cm) between all sides of side burner and walls or
other combustible material. DO NOT use side burner under overhead unprotected combustible
construction.
• DO NOT use or install this side burner in or on a recreational vehicle and/or boat.
FOLLOW THE INSTRUCTIONS FOR CONNECTING YOUR STAINLESS STEEL NATURAL GAS
DROP-IN 4-BURNER GRILL TO THE NATURAL GAS SOURCE.
These instructions are located in the 810-6835-0 Stainless Steel Natural Gas Drop-In 4-Burner Grill owner's
manual. After main grill installation follow the instructions below for connecting your side burner to the
Quick-Disconnect coupler.
Connect the side burner hose
fitting to the grill body hose by
inserting the fitting into the
quick-disconnect coupler.
• Never use your grill without leak testing all gas connections and hoses. See the section on
"Leak Testing" in this manual for proper procedures.
• Visually inspect the hose assembly prior to each use for evidence of damage, excess wear or
deterioration. If found, replace the assembly before using your grill. Only the Brinkmann
supplied replacement should be used.

LEAK TESTING:

To prevent fire or explosion hazard:
• DO NOT smoke or permit ignition sources in the area while conducting a leak test.
• Perform test OUTDOORS only in a well ventilated area.
• Never perform a leak test with a match or open flame.
• Never perform a leak test while the side burner is in use or while side burner is still hot.
WARNING
Quick-Disconnect Coupler
WARNING
DANGER
Push sleeve back to attach
Sleeve Side Burner Hose Fitting
4