Vrm Installation; Peripheral Device Installation - TYAN Single S1662S User Manual

3.12 VRM Installation

The VRM is required for the Pentium Pro to work. The CPU will
program the VRM for the correct voltage needed. No jumper settings
are needed, just install the VRM into the VRM socket nearest the
CPU that is being installed. The VRM can only fit in the socket one
way so there is no danger of installing it incorrectly. Not all VRM's
will work in the S1662. Make sure you purchased a qualified VRM.
w VRM socket 0 is for CPU socket 0.
w VRM socket 1 is for CPU socket 1.

3.13 Peripheral Device Installation

After all the jumpers on the mainboard have been set, then it can be mounted
into the case. Then proceed to install the display card and any other
peripheral devices.
If a PCI-Bus interface card is to be installed in the system, any one of the
five PCI-Bus slots can support either a Master or a Slave device.
After installing the peripheral controllers, the user should check everything
again, and prepare to power-on the system.
S1662-AT-001 http://www.tyan.com 16