Contents 1 Important Safety Notice 2 Your CD Soundmachine Introduction What's in the box Overview of the main unit 3 Get started Connect power Turn on Turn off 4 Play Play a CD Play from an external device Play from USB devices Play from SD card Play tape Tune to FM radio stations...
• Do not mix batteries (old and new or Philips Consumer Lifestyle may void the user’s carbon and alkaline, etc.). authority to operate the equipment. • Remove batteries when the unit is not...
Page 4
This apparatus includes these labels: Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. Class II equipment symbol When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/ This symbol indicates that the apparatus has a double insulation system.
2 Your CD Overview of the main unit Soundmachine Introduction With this CD Soundmachine, you can: • listen to FM radio; • enjoy audio from discs, tapes, USB device, Micro SD card, and other external audio devices; • program the play sequence of tracks. The unit offers you Dynamic Bass Boost (DBB) to enrich sound.
Always follow the instructions in this chapter in • Tune to FM radio stations. sequence. If you contact Philips, you will be asked for the model and serial number of your apparatus. The • USB socket. model number and serial number are on the n Source selector bottom of your apparatus.
Turn on Switch the source selector on the main unit to FM/USB/SD/CD. » When the source selector is in the CD position, CD is displayed. AC~MAINS Switch to standby mode • The unit switches to standby mode automatically when there is no audio detected for over 15 minutes.
4 Play Play from an external device You can also listen to an external audio device through this unit. Connect an audio cable (3.5mm, not Play a CD supplied) to: • the AUDIO-IN socket on the unit. • the headphone socket on an external Note device.
Play from USB devices Play from SD card Note Note • • Make sure that the USB device contains playable audio Make sure that the SD card contains playable audio content. content. Switch the source selector to USB/SD. Switch the source selector to USB/SD . Insert the USB device into the socket.
Play tape Tune to FM radio stations Note Slide the source selector to TAPE. Press on main unit to open the tape • For optimal reception, fully extend and adjust the door. position of the FM antenna. Load the tape with the open side upward and the full spool to the right.
5 Play options Program tracks In CD/USB/SD mode, you can program a maximum of 20 tracks. Press to stop playback. Control play Press PROG to activate the program mode. In CD mode, you can control play through the » [PROG] (program) begin to blink. following operations.
6 Product Tuner information Tuning Range 87.5 - 108MHz Tuning grid 50 kHz Total Harmonic Distortion <3% Note Signal to Noise Ratio >50 dBA • Product information is subject to change without prior notice. Tape deck Frequency response 125 - 8000 - Normal tape (type I) Hz (8 dB) Specifications...
Clean the disc lens • After prolonged use, dirt or dust may accumulate at the disc lens. To ensure good play quality, clean the disc lens with Philips CD lens cleaner or any commercially available cleaner. Follow the instructions supplied with cleaner.
If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available.