Contents 1 Important Safety Notice 2 Your CD Soundmachine Introduction What's in the box Overview of the main unit 3 Get started Connect power Turn on Turn off 4 Play Play a CD Play from an external device Play from USB devices Play from SD card Play tape Tune to FM radio stations...
1 Important • Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. • CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. Safety • The unit shall not be exposed to dripping or splashing.
Page 4
This apparatus includes these labels: Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. Class II equipment symbol When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/ This symbol indicates that the apparatus has a double insulation system.
2 Your CD Overview of the main unit Soundmachine Introduction With this CD Soundmachine, you can: • listen to FM radio; • enjoy audio from discs, tapes, USB device, Micro SD card, and other external audio devices; • program the play sequence of tracks. The unit offers you Dynamic Bass Boost (DBB) to enrich sound.
Always follow the instructions in this chapter in • Tune to FM radio stations. sequence. If you contact Philips, you will be asked for the model and serial number of your apparatus. The • USB socket. model number and serial number are on the n Source selector bottom of your apparatus.
Turn on Switch the source selector on the main unit to FM/USB/SD/CD. » When the source selector is in the CD position, CD is displayed. AC~MAINS Switch to standby mode • The unit switches to standby mode automatically when there is no audio detected for over 15 minutes.
4 Play Play from an external device You can also listen to an external audio device through this unit. Connect an audio cable (3.5mm, not Play a CD supplied) to: • the AUDIO-IN socket on the unit. • the headphone socket on an external Note device.
Play from USB devices Play from SD card Note Note • • Make sure that the USB device contains playable audio Make sure that the SD card contains playable audio content. content. Switch the source selector to USB/SD. Switch the source selector to USB/SD . Insert the USB device into the socket.
Play tape Tune to FM radio stations Note Slide the source selector to TAPE. Press on main unit to open the tape • For optimal reception, fully extend and adjust the door. position of the FM antenna. Load the tape with the open side upward and the full spool to the right.
5 Play options Program tracks In CD/USB/SD mode, you can program a maximum of 20 tracks. Press to stop playback. Control play Press PROG to activate the program mode. In CD mode, you can control play through the » [PROG] (program) begin to blink. following operations.
6 Product Total Harmonic Distortion <3% Signal to Noise Ratio >50 dBA information Tape deck Note Frequency response 125 - 8000 - Normal tape (type I) Hz (8 dB) • Product information is subject to change without prior Signal-to-noise ratio 35 dBA notice. - Normal tape (type I) Wow and flutter ≤ 0.4% Specifications General Power supply...
If the problem remains • After prolonged use, dirt or dust may unsolved, go to the Philips Web page (www. accumulate at the disc lens. To ensure good philips.com/support). When you contact Philips, play quality, clean the disc lens with Philips...
Page 14
Poor radio reception • Increase the distance between the unit and your TV or VCR. • Fully extend the FM antenna.