Teleco UST DK User Manual page 95

––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
To cancel an advisory message that has been set at your station
Press
...or [PDN] +
The LED goes out. If a station message was sent, this procedure does not erase it.
Remote Advisory Station Messaging
To set an advisory station message for another station
1. While your telephone
is idle, press
.
2. Dial the destination
[PDN].
3. Press
4. Enter the message
number (station
5. Press
6. Press
7. Press .
LCD Operation
+ .
+
= the destination [PDN]
207
.
(This assumes the message is already
stored in memory.)
; system,
).
. Remote calling station messaging
allows you to set a calling station
message for only one station at a time.
. = the [PDN] where message will
207
be set.
= the message number.
010
= message is set.
M
Your LCD shows the time and date.
The message is displayed at station
. LCD telephones calling station
207
receives the message.
207
Messages
MODE 95
DEST EKT NO.?
MODE 95 DEST EKT
EKT NO. 207
MW TO ST123
MSG NO?
MW TO STXXX
MSG NO?10
CALL 207-010M
Called station
SENT 207
Your station
95