Drip Tray; Metal Doors; Glass Shelf; Door Sealing - Norcold N109X Owner's Manual

Drip tray:

To remove and clean the drip tray:
NOTE: Do not wash the drip tray in a dishwasher. The drip tray
is not dishwasher safe.
- Pull the drip tray out of the drain hose.
- Pull the drip tray forward to remove from the slots in the
refrigerator cabinet.
- Clean the drip tray.
- Push the drip tray back into the slots in the refrigerator
cabinet.
- Push the drip tray back into the drain hose.

Metal doors:

To clean the metal doors:
- Wash the doors with a mild cleaner or a solution of liquid dish
detergent and warm water.
- Rinse with clean water.
- Dry with a clean cloth.
NOTE: Do not use abrasive cleaners, chemicals, or
scouring pads because they can damage the
metal doors.

Glass shelf:

To clean the glass shelf:
- Remove the screw and grommet that is in front of the glass
shelf.
- Pull the glass shelf forward out of the slot
- After cleaning, push the glass shelf fully into the slot.
- Put the screw and grommet back in the orignial position.

Door Sealing

Check the seal of the doors.
If either door does not seal correctly, excess frost will collect
inside the refrigerator. Make sure the doors seal correctly (See
Art00980):
- Close each door on a piece of paper that is about the size
and thickness of a dollar bill.
- Gently pull the paper.
- You should feel a slight drag between the gasket and the
cabinet.
- Do this on all four sides of the door.
- If you do not feel a slight drag on the
paper, the door does not seal correctly.
- Have your dealer or an authorized Norcold Service
Center correct the seal of the door.

Refrigerator Maintenance Checklist

Read and understand the following maintenance sections of this
manual.
NOTE: Norcold is not responsible for installation,
adjustment, alteration, service, or maintenance
performed by anyone other than a qualified RV
dealer or a Norcold authorized service center.
Have a qualified RV dealer or a Norcold authorized service
center do these annual safety and maintenance checks:
- Examine the gas supply lines for leaks.
- Replace or repair if needed.
- Make sure the propane gas pressure is 11 inches of water
column.
- Adjust if needed.
- Make sure the combustion seal is complete and intact.
- Replace or repair it if needed.
- Make sure the burner and the burner orifice are clean.
- Clean if needed.
- Make sure the electrode spark gap is 1/8 - 3/16 inch.
- Adjust if needed.
- Make sure the AC voltage is 108 - 132 volts and the DC
voltage is 10.5 - 15.4 volts.
- Make sure the thermocouple tip is clean and secure.
- Make sure the area at the rear of the refrigerator is free of
any combustible materials, gasoline, and other flammable
vapors and liquids.
Owner's Manual 9