Genie EDVR-4 User Manual page 31

Use <+> button to select Motion Grid at Front Panel . Running Man Icon
will be activated. <+> button is used for selecting and cancel. Use <-> button to
escape from Grid Menu.
It is also possible to select smaller motion grids for more precise motion
detection by using CMS.
5. Save changes and exit the menu, press [ENTER] button. Then go "RECORD" Menu.
6. Select "ON" or "OFF" to Enable or Disable motion detection on a per camera, as
shown below.
Press the REC button, then Motion recording starts according to configured Recording
7.
Quality, Frame Rate when Motion detected. It will be back to stand-by mode after
motion recording time is end. Camera does not record under normal conditions.
Note> Motion Duration will be extended if there is another motion detection while
<
motion recording.
<Note> There may be cases when the recorder's built-in motion detection function does
not operate properly due to the condition of the input video signal or other factors.<
<Note> It is recommended selection of at least 3 motion blocks to get more accurate
motion recording.
30
DIGITAL VIDEO RECORDER