Grizzly G0690 Owner's Manual page 66

symptom possible Cause
Blade is not aligned 1. Blade is warped.
with miter slot or
2. table top is not parallel to blade.
fence.
3. Fence is not parallel to blade.
Blade does not 1. 90° stop bolt is out of adjustment.
reach 90°.
2. sawdust stuck on stop bolt.
Blade hits insert at 1. 45° stop bolt is out of adjustment.
45°.
2. sawdust stuck on stop bolt.
3. hole in insert is inadequate.
4. table out of alignment.
5. Blade position is incorrect.
Board binds or 1. dull blade.
burns when feeding
2. Blade is warped.
through table saw.
3. Fence is not parallel to blade.
4. table top is not parallel to blade.
-64-
possible solution
1. replace blade (page 36).
2. Make table parallel to blade (page 67).
3. Make fence parallel to blade (page 69).
1. adjust 90° stop bolt (page 65).
2. Clean sawdust off stop bolt.
1. adjust 45° stop bolt (page 65).
2. Clean sawdust off stop bolt.
3. File or mill the hole in the insert.
4. align blade to the table (page 67).
5. adjust blade position.
1. replace blade.
2. replace blade (page 36).
3. Make fence parallel to blade (page 69).
4. Make table parallel to blade (page 67).
Model g0690/g0691 (Mfg. 11/10+)