Table of Contents
Advertisement
To recharge the batteries connect the adapter.
The battery icon will animate to show it is charging.
appears with no animation when the battery is fully
recharged. Charge the batteries for 12 hours before 1st use
and press RESET. After the first charge, you only need to
charge the unit until the battery icon shows it is full.
LOW BATTERY
Flashes when the baby unit battery is low and
sounds warning beeps every minute until the
battery is dead
Flashes when the parent unit battery is low
and sounds warning beeps every minute until
the battery is dead
NOTE Press RESET after each battery change.
NECK STRING – PARENT UNIT
TURN ON / OFF
To turn a unit ON or OFF, press and hold
SET UP
1. Insert batteries / adapters (as shown in the Power section).
2. Turn the baby unit ON and then the parent unit.
3. Place the 2 units close to each other for 5 seconds. This
4. Position the units no more than 300 meters (984 feet)
For best results:
•
•
•
5
5
allows the units to recognize each other as family.
from each other.
Place the units away from electrical or mechanical objects,
direct sunlight and moisture.
Do not exceed the 300-meter (984-foot) transmission
range of the units.
Minimize obstructions such as doors, walls and furniture
as this will decrease the transmission range between the
2 units.
11/28/2005, 12:05 PM
.
Advertisement
Table of Contents
