How To Stop Your Pressure Washer; How To Use Accessory Tray - Troy-Bilt 1904 Owner's Manual

Section 4: Operation
10. Start engine according to instructions given in the
engine owner's manual.
NOTE: If the recoil starter is hard to pull, it may be
necessary to squeeze the gun trigger to relieve internal
pump pressure.
CAUTION
Avoid injury from kickback.
• Squeeze trigger on spray gun each time recoil starter is
pulled and engine fails to start.

How to Stop Your Pressure Washer

• Move variable pressure control lever to "Stop" position.
• Turn engine off according to instructions given in the
engine owner's manual.
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when you
release the pressure.

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to
store your nozzle extension and quick connect spray tips,
and slots to hold the cleaning solution bottle and the
detergent siphoning filter.There are also two hooks at the
ends of the handle to hold your spray gun and high
pressure hose.
NOTE: The extra holes in the tray are for storing a brush
and a turbo wand.The brush and turbo wand are NOT
included with your pressure washer.You can buy these
items as optional accessories.
1. Place nozzle extension through hole on accessory tray,
as shown in Figure 13.
Figure 13 — Typical Accessory Tray
2. Hang chemical solution bottle on "J" hook and place
detergent siphoning filter in last slot on left (Figure 13).
3. Place spray gun on hook attached to accessory tray on
right side of unit (Figure 13).
4. Hang high pressure hose on hook attached to
accessory tray on left side of unit as shown on page 4.
10