Section 4: Operation; How To Stop Your Pressure Washer; How To Use Accessory Tray - Troy-Bilt 01904 Owner's Manual

10. Start the engine according to instructions given in the
engine owner's manual.
NOTE: If the recoil starter is hard to pull, it may be
necessary to squeeze the gun trigger to relieve internal
pump pressure.

How to Stop Your Pressure Washer

• Move variable pressure control lever to "Stop" position.
• Turn engine off according to instructions given in the
engine owner's manual.
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when you
release the pressure.

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to
store your nozzle extension and quick connect spray tips,
and slots to hold the cleaning solution bottle and the
detergent siphoning filter.There are also two hooks at the
ends of the handle to hold your spray gun and high
pressure hose.
NOTE: The extra holes in the tray are for storing a brush
and a turbo wand.The brush and turbo wand are NOT
included with your pressure washer.You can buy these
items as optional accessories.

Section 4: Operation

1. Place the nozzle extension through the hole on the
accessory tray, as shown in Figure 13.
Figure 13 — Typical Accessory Tray
2. Hang your chemical solution bottle on the "J" hook
and place the detergent siphoning filter in the last slot
on the left (Figure 13).
3. Place the spray gun on the hook attached to the
accessory tray on the right side of the unit (Figure 13).
4. Hang the high pressure hose on the hook attached to
the accessory tray on the left side of the unit as shown
on page 4.
9