Scan-Resume Option - Yaesu FT-1900E Operating Manual

Three scan-resume modes are available on the FT-1900E:
In the "BUSY" mode, the scanner will remain halted for as long as there is carrier present
on the channel; after the carrier drops at the end of the other station's transmission,
scanning will resume.
In the "HOLD" mode, the scanner will halt on a signal it encounters. It will not restart
automatically; you must manually re-initiate scanning if you wish to resume.
In the "3SEC/5SEC/10SEC" mode, the scanner will halt for the selected resume time,
after which scanning will resume (whether or not the other station is still transmitting).
The default scan-stop mode is "BUSY." To change the scan-resume mode, use the following
procedure:
1. Press and hold in the [ MHz ( SET )] key for one second, then
rotate the DIAL knob to select "41 RESUME."
2. Press the [ MHz ( SET )] key, then rotate the DIAL knob to
select the desired scan-resume mode.
3. Press and hold in the [ MHz ( SET )] key for one second to save the new setting and exit
to normal operation.
FT-1900E O
S -R
CAN ESUME
M
S
O
PTIONS
CANNING
45