Table of Contents
Advertisement
DHCP Server
DHCP allows networked devices to obtain information on the parameters of IP, Netmask, and so
forth through the Ethernet Address of the device.
DHCP Type: To configure the device's DHCP Server, select Server from the DHCP Type drop-
down menu and you can then configure parameters of the DHCP Server.
DHCP Start IP/ End IP: Enter the starting and ending IP address of the range of IP addresses
that you want the DHCP server to assign to DHCP clients. The default DHCP IP range is
192.168.1.2 to 192.168.1.50.
DHCP Subnet Mask: Enter the subnet mask for the network address that you specified. The
default is 255.255.255.0.
DHCP Lease Time: Enter the time value (in seconds) that you want the assigned IP address to be
valid for. The DHCP client must obtain a new IP address from the DHCP server when this value
expires.
Statically IP Assigned: You can map the MAC address for stations that you want to always be
assigned the same IP address. Mapped IP addresses must be outside the DHCP start/end IP
range. You can configure up to 3 sets of MAC and IP addresses in this table.
49
Advertisement
Table of Contents
