Table of Contents
Advertisement
Symptom
Possible Cause
Machine has vibra-
1. Motor or component is loose.
tion or noisy opera-
tion.
2. Flat belt worn or loose.
3. Motor fan is rubbing on fan cover.
4. Pulley is loose.
5. Machine sits unevenly on floor.
6. Arbor bearings are at fault.
7. Arbor pulley is loose.
8. Workpiece is loose.
9. Motor bearings are at fault.
10. Blade is at fault.
11. Loose arbor nut
12. Centrifugal switch (single-phase).
Table Saw Operations
Symptom
Possible Cause
Blade is not aligned
1. Blade is warped.
with miter slot or
2. Table top is not parallel to blade.
fence.
3. Fence is not parallel to blade.
Blade
does
not
1. 90° stop bolt is out of adjustment.
reach 90°.
2. Sawdust loaded up on positive stop.
Blade hits insert at
1. 45° stop bolt is out of adjustment.
45°.
2. Hole in insert is inadequate.
3. Table out of alignment.
4. Blade position is incorrect.
Board
binds
or
1. Dull blade.
burns when feeding
2. Blade is warped.
through tablesaw.
3. Fence is not parallel to blade.
4. Table top is not parallel to blade.
-46-
Possible Solution
1. Inspect/replace stripped or damaged bolts/nuts, and
re-tighten with thread locking fluid.
2. Inspect/replace flat belt with new one (refer to Page
47).
3. Replace dented fan cover; replace loose/damaged
fan.
4. Realign/replace shaft, pulley, set screw, and key as
required.
5. Relocate/shim machine.
6. Replace arbor housing bearings; replace arbor.
7. Retighten/replace arbor pulley with shaft and thread
locking liquid.
8. Use the correct holding fixture and reclamp
workpiece.
9. Test by rotating shaft; rotational grinding/loose shaft
requires bearing replacement.
10. Replace warped, bent, or twisted blade; resharpen
dull blade.
11. Tighten the arbor nut.
12. Replace centrifugal switch.
Possible Solution
1. Replace blade (Page 22).
2. Make table parallel to blade (Page 51).
3. Make fence parallel to blade (Page 54).
1. Adjust 90° stop bolt (Page 49).
2. Clean sawdust off positive stop.
1. Adjust 45° stop bolt (Page 49).
2. File or mill the hole in the insert.
3. Align blade to the table (Page 51).
4. Adjust blade position.
1. Replace blade.
2. Replace blade (Page 22).
3. Make fence parallel to blade (Page 54).
4. Make table parallel to blade (Page 51).
G0605X/G0606X Extreme Series 12" Table Saw
Advertisement
Table of Contents
