Grizzly G0591 Instruction Manual page 32

7.
Slide the aluminum rip fence all the way onto
the clamping plate (Figure 25) and secure it
by rotating the locking handle on top of the rip
fence body.
Clamping
Plate
Figure 25. Installing the rip fence.
10. Rotate the adjusting nut of the stud on the
far right until the rip fence is parallel with the
edge of the table as shown in Figure 26.
Tighten the nut inside the lip of the table to
secure the stud, then tighten the outside nut
against the adjusting nut.
Note: Leave the center studs loose until the
adjustment are complete.
Adjusting
Nut
Sliding
Table
Figure 26. Aligning the fence with the edge of
the stationary table.
11. Replace the stop screw into the round rail.
12. Slide the rip fence along the rail and make
sure the gap between the rip fence body and
the table is equal along the entire distance.
-24-
13. Adjust the height of the rip fence rail, then
14. Check if the bottom of the rip fence rests on
Rip
Fence
tighten all of the nuts securing the rail against
the table (see Figure 27) and tighten the out-
side nuts against the adjusting nuts.
Figure 27. Rip fence rail adjustment nuts.
the surface of the table.
— If the rip fence does not rest on the table,
then the fence is correctly adjusted.
— If the rip fence does rest on the table,
loosen the hex nut shown in Figure 28
and rotate the hex bolt to raise the roller.
Tighten the hex nut to lock the height.
Note: The rip fence will scratch the table
surface if the ride height is not adjusted cor-
rectly.
Figure 28. Rip fence height adjustment.
G0588/G0591 12" Sliding Table Saws