Hifonics Atlas AXi3003 Owner's Manual page 16

LOGO BADGE
1
BEFORE THE CONNECTION
Appropriate wiring kits for professional installations of a sound system are available in car audio retailer stores. Please ensure the sufficient
profile section of at least 25 mm
and remove rust-streaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws
are fixed tight after the installation, because loosely connections may cause malfunctions, insufficient power supply or interferences.
LOGO BADGE
1
With this switch you can choose between white or blue illumination of the upper logo badge.
Always follow the guidelines of your national road traffic regulations.
GND
2
Connect this GROUND terminal with a suitable contact ground point on the vehicle's chassis. The ground wire must be as short
as possible and must be connected to a blank metallic point at the vehicle's chassis. Ensure that this ground point has a stable
and safe electric connection to the negative "–"pole of the battery. Check this ground wire from the battery to the ground point if
possible and enforce it, if required. Use a ground wire with a sufficient cross section (at least 25 mm
plus (+12V) power supply wire.
REM
3
Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote signal of your headunit with the REM-terminal of the
amplifier. Use therefor a suitable cable with a sufficient cross section (0,5 mm
with your headunit.
BATT+12V
4
Connect the BATT+12V-terminal with the +12V pole of the vehicle's battery. Use therefor a suitable cable with a sufficient cross
section (min. 25 mm ) and install an additional in-line fuse. For safety reasons the distance between the fuseblock and the battery
2
must be shorter than 30 cm. Do not install the fuse into the fuseblock until the installation is accomplished.
FUSE
5
The inserted fuses protect the amplifier from shorts and capacity overload.
REFERENCE NOTE
Installation of RCA/Audio signal cables and power supply.
Please install if possible the audio cables from the headunit and the amplifier not together with the power
supply wires on the same side of the vehicle. The best is an areal separated installation in the left and right
cable channel of the vehicle. This avoids an overlap of interferences on the audio signal. This also applies
for the supplied bass-remote connection, which should not be installed together with the power supply
wires. It is recommended to use the same side like the audio cables.
INSTALLATION INSTRUCTION
ELECTRICAL INTERCONNECTION
GND REM BATT + 12V FUSE
BLUE
WHITE
POWER INPUT
2 3 4 5
, the suitable fuse rating and the conductivity of the cables when you purchase your wiring kit. Clean
2
SPEAKER OUTPUT SUB OUTPUT
+ – + – +
CH 1 CH 2
). Thereby the amplifier will turn on or off automatically
2
16
–
) and the same size like the
2