Table of Contents
Advertisement
Qosmio F60 Series
Installing a memory module
The computer contains slots for two memory modules, one positioned
immediately over the other - the procedures are the same for installing
either module.
1. Shut down the computer - make sure the Power indicator is off (refer to
the
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack
Modes, if required).
5. Loosen the screw securing the memory module cover in place - please
note that this screw is attached to the cover in order to prevent it from
being lost.
6. Slide your fingernail or a thin object under the cover and lift it off.
3-24
Turning off the power
1
2
1. Screw
Figure 3-4 Removing the memory module cover
section in Chapter 1,
section in Chapter 6,
2. Memory module cover
Getting
Started, if
Power and Power-Up
User's Manual
Advertisement
Table of Contents
