Table of Contents
Advertisement
180
Troubleshooting
Sound problems
Sound problems
Check the antenna/cable connections, see
system" on page
The station may be having broadcast difficulties. Try another channel.
The sound may be muted. Press the VOL (+ -) buttons or MUTE button.
If you are connected to a computer using either the PC IN terminal or
an HDMI
properly set, see
Remote control problems
Remove all obstructions between the remote control and the TV.
Replace the remote control's batteries, see
50.
Your TV's remote control may not operate certain features on your
external device. Refer to the owner's manual for your other device to
determine its available features. If your TV remote control does not
operate a specific feature on another device, use the remote control that
came with the device, see
53.
If the TV still does not act as expected, perform the Reset Factory
Defaults procedure, see
Channel tuning problems
Ensure that the remote control is set to the correct device mode, see
"Learning about the remote control" on page
The Auto Tuning feature may have erased the channel from memory. To
add the channel to the channel memory, see
70.
The Lock feature may have blocked the channel. To unblock the channel,
see
"Unlocking programs" on page
If you cannot tune digital channels, check the antenna configuration, see
"Initial setup" on page
from the channel list and reprogram channels into memory, see
channels in memory (optional)" on page
see
"TV stops responding to controls." on page
persists, use the Reset Factory Defaults procedure, see
Factory Defaults" on page
38.
™
terminal, make sure that the Rear Shared Audio setting is
"Connecting a digital audio system" on page
"Resetting to Factory Defaults" on page
55. If the problem persists, clear all channels
"Connecting a digital audio
"Learning about the remote control" on page
93.
69. For additional information,
105.
"Installing batteries" on page
53.
"Manual Tuning" on page
177. If the problem
"Resetting to
38.
105.
"Storing
Advertisement
Table of Contents
