IBM 6385 User Manual page 48

10. Carefully grasp the adapter by the top edge or upper corner, and insert it in the
11. If you have another adapter to install, do so now. Otherwise, continue with step
12. If any cables need to be connected to an adapter, connect them. These cables
13. Align the tabs on the PCIe adapter bay cover with the holes on the expansion
14. Install the PCIe adapter bay cover screws.
15. Follow the cabling instructions, if any, that come with the adapter. If possible,
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 42.
36
IBM dx340 User's Guide
7. Touch the static-protective package that contains the adapter that you are
installing to any unpainted metal surface on the chassis or rack; then, remove
the adapter from the static-protective package. Avoid touching the components
and gold-edge connectors on the adapter.
8. If you are installing a full-length adapter, remove the blue adapter guide (if any)
from the end of the adapter.
Adapter guide
9. Follow the instructions that come with the adapter to set any jumpers or
switches.
two-slot riser card. Align the adapter with the connector on the riser card; then,
press the adapter firmly into the connector.
13.
should be routed through the hole at the side of the expansion enclosure.
enclosure; then, slide the PCIe adapter bay cover toward the rear of the
expansion enclosure until it stops.
route the adapter cables before you install the expansion enclosure on the
chassis.