Hunter 90397 Owner's Manual page 6

1.
Unscrew the Height Adjustment Knob (P) on the External Pole (Q) and set aside. Attach the External Pole (Q) to
the Base (V) by inserting and tightening the four Screws (U) included.
2.
Slide the stand cover (t) over the External Pole (Q) into the ring on the Base (V).
3.
Use your finger to pull out the Internal Pole (O). Slide the Height Adjustment Knob (P) over the Internal Pole
(O). Fasten it to the External Pole (Q) by turning the Height Adjustment Knob (P) clockwise while holding the
Internal Pole (O). Make sure the Height Adjustment Knob (P) is tightly fastened before final assembly.
4.
Slide the Waterproof Cover (M) over the Internal Pole (O) until it covers the top of the Height Adjustment Knob
(P).
grIll asseMBly (FIgures 2. & 3.)
1.
Remove the Blade Cap (B) by turning clockwise, the Plastic Nut (D) by turning counterclockwise from the Motor
Housing (I), and the Plastic Sleeve (F) by pulling it straight off the Motor Shaft (G). Discard only the plastic sleeve.
2.
Position the Rear Grill (E) over the Motor Shaft (G), making certain the handle is at the top and the one notch in
the center of the Rear Grill (E) cover fits over the three prong post on the Motor Housing (I).
3.
Secure the Rear Grill (E) with the Plastic Nut (D) turning clockwise to tighten firmly.
4.
Slide the Fan Blade (c), with the hollow interior of the blade facing towards the Rear Grill (E), onto the Motor
Shaft (G). Line the cut-out on the back of the Fan Blade (C) with the retaining pin on the Motor Shaft (G).
5.
Secure the Fan Blade (C) onto the Motor Shaft (G) by turning the Blade Cap (B) counterclockwise until it is firmly
in place.
6.
Loosen the bolt on the bottom of the Front Grill (A) and mount the Front Grill (A) with the logo right side up to
the Rear Grill (E) by snapping both together firmly.
nOte: Ensure all snaps around the Front Grill (A) are secure on the Rear Grill (E).
7.
Tighten the bolt on the bottom of the Front Grill (A).
6
Base asseMBly (FIgure 1.)
M
O
P
T
Q
U
V
Figure 1.
C
D
I
G
F
B
E
K
Retaining Pin
Figure 2.
A
E
Figure 3.
K
©2010 Hunter Fan Co.