J1: Spi Flash Connector (Factory Use Only); J2: Audio Connector; J4: Lpc Connector (Factory Use Only); J5: System Function Connector - American Megatrends IB892 User Manual

J1: SPI Flash Connector (factory use only)

J2: Audio Connector

Signal Name
LINE-OUT_L

J4: LPC Connector (factory use only)

J5: System Function Connector

ATX Power ON Switch: Pins 1 and 2
This 2-pin connector is an "ATX Power Supply On/Off Switch" on the
system that connects to the power switch on the case. When pressed, the
power switch will force the system to power on. When pressed again, it
will force the system to power off.
Hard Disk Drive LED Connector: Pins 3 and 4
This connector connects to the hard drive activity LED on control panel.
This LED will flash when the HDD is being accessed.
Pin # Signal Name
4 HDD Active
3
Reset Switch: Pins 5 and 6
The reset switch allows the user to reset the system without turning the
main power switch off and then on again. Orientation is not required
when making a connection to this header.
+5V and 5VSB Signals: Pins 7 and 8
Pin # Signal Name
7
8
JD-OUT
LINE-IN_L
JD-IN
Mic-In L
JD-Mic
5V
+5V
+5VSB
IB892 User's Manual
Pin # Pin #
1 2
3 4
5 6
7 8
9 10
11 12
INSTALLATIONS
Signal Name
LINE-OUT_R
Ground
LINE-IN R
Ground
Mic-In R
Ground
13