Connecting The Speakers; Painting; Vi. Painting - PSB Owner's Manual

Figure 4:
V. CONNECtING tHE SPEAKERS
Connect each speaker with a standard two-wire cable to the signal source either directly
or through a local volume control. The speakers must be wired appropriately for the
intended control. The impedance loads of the speakers must be balanced with the
capabilities of the amplifier. in some mono-only systems, a single wire may be connecting
speakers in series, entering from one speaker to another—beginning and ending at the
amplifier. Wire gauge should decrease with longer runs—usually 16AWG (1.3mm dia)
stranded copper wire is minimal, with 12 AWG (2.0mm dia) being better for longer runs.
The ends of each wire need to be separated, stripped, twisted and inserted into the
correct terminal post. Polarity needs to be maintained to ensure in-phase connection for
maximum bass and clarity. Out-of-phase connection will result in frequency cancellations
and produces thinner, less distinct sound—with less bass, vague vocal quality and no
solid centre image.
To help ensure proper connection, the two separate conducting wires in a standard two-
conductor speaker cable are coded in one way or another to be distinguishable from each
other (for example +/rib/writing/red).

VI. PAINtING

Before painting, the Grille has to be separated from the enclosure. Starting at the baffle
groove detail, use the supplied Grille puller to gently pull along the edge of the Grille,
until the Grille comes out. The Rubber Terminal Cover, Aluminium Bracket and Knobs need
to be removed as well.
Carefully mask the baffle, terminals, threaded inserts and logo on the Grille. Lightly sand
the enclosure, Grille, Aluminium Bracket, Plastic Wall Plate and Knobs. Using a cloth
moistened with mild detergent remove paint residue and any grease contamination.
Let dry. For best results apply several light paint coats instead of one heavy coat. This is
especially important for the Grille, to prevent clogging of the perforations. Application of
primer prior to top coating is recommended.
5
3
6
1
6
2
4