Aiming And Positioning The Speakers; Weather Resistance; Iv. Weather Resistance - PSB Owner's Manual

Figure 3:
III. AIMING AND POSItIONING tHE SPEAKERS
The speaker can be tilted up or down by loosening the two Set Screws located on the
right side of the Plastic Wall Plate and sliding the speaker on the curved Aluminium
Bracket to the desired position and tightening the Set Screws.
The speaker can be turned to the left or to the right side by loosening both plastic Knobs
and then tightening them again after the desired position is achieved.

IV. WEAtHER RESIStANCE

Materials used in building PSB Universal speakers have been selected for their durability,
while providing excellent sonic performance in most indoor and outdoor applications.
For outdoor applications, preference should be given to locations that provide protection
from the elements.
During extreme weather conditions, the Port (if applicable) should be closed with the
supplied Port Plug to prevent water from entering the speakers.
To access the port (if applicable), the Grille needs to be removed by using the supplied
Grille puller and gently pulling along the Grille's edge, starting at the groove in the
middle of the speaker. With the Port Plug installed, carefully install the Grille by gently
applying pressure around the perimeter of the Grille, in the sequence illustrated in
Figure 4.
For outdoor applications, we recommend covering the terminals with the supplied Rubber
Terminal Cover (Figure 3).
Rubber Terminal Cover
5