The Live View Page - Axis Q1910 User Manual

The Live View page

If your network camera has been customized to meet specific requirements the buttons and other items described below may
or may not be displayed on the Live View page. The following provides an overview of each available button.
General controls
The Stream Profile drop-down list allows you to select a customized or pre-programmed stream
profile on the Live View page. Stream profiles are configured under Video & Audio > Stream Pro-
files, see Stream Profiles, on page 21, for more information.
The Palette drop-down list allows you to apply a palette to the image. See Image Appearance, on
page 19.
The Trigger buttons can trigger an event directly from the Live View page. These are configured
under Setup > Live View Config > Layout.
(AXIS Q1910-E/Q1921-E/Q1922-E) The Heater button manually starts the heater. Set the number of
minutes the heater should run when the button is clicked.
The Snapshot button saves a snapshot of the video image currently on display. Right-click on the
video image to save it in JPEG format on your computer. This button is primarily intended for use
when the AXIS Medial Control viewer toolbar is not available.
The Output buttons control the output directly from the Live View page. These buttons are config-
ured under Setup > Live View Config > Layout:
Pulse – Click this button to activate the output for a defined period of time, e.g. switching a light on
for 20 seconds.
Active/Inactive – Click these buttons to manually start and stop a connected device, e.g. switch a
light on/off.
Audio clips can be played manually from the Live View page. Select the audio clip from the
drop-down list and click play.
AXIS Media Control toolbar
The AXIS Media Control viewer toolbar is available in Internet Explorer only. See AXIS Media Control (AMC), on page 17 for
more information. The toolbar displays the following buttons:
The Play button connects to the product and playing a live video stream.
The Stop button stops the live video stream being played.
The Snapshot button saves a snapshot of the video image on display. The image is saved in the folder specified in
the AMC Control Panel.
Click the View Full Screen button to make the video image fill the entire screen area. Press Esc (Escape) on the
computer keyboard to exit full screen, or right-click and select the option to exit.
The Record button is used to start a recording directly from the Live View page. The recording is saved in the folder
specified in the Recording tab in the AMC Control Panel.
AXIS Q19 Series - Accessing the camera
14