Table of Contents
Advertisement
3) Resetting methods
Error
No-paper
Head-up
VH voltage error
Head temperature error
Cutter lock(ACS-220-5v)
Note)
1.
If auto loading has not been selected with the function selection J4(Jumper), set the
paper manually.
facilitate paper replacement.
2.
The upper-limit voltage of 8.5V for the VH voltage error is a voltage assumed only
immediately after charging the battery when the battery power is used and cannot be
normally used. A maximum normal voltage is 7.2V.
Set the paper. See Note 1.
Shift down the head-up lever.
Set the VH voltage to within the allowable range(4.2~8.5 V) and
turn on the power again, or set the LFSW(Pin-2) of the CPU to
Active. See Note 2.
At the lower limit(Less than 0ºC), printing is enabled at 0ºC or
more.
At the upper limit(65ºC or more), printing is enabled at
60 C or less.
Eliminate the paper jam and set LFSW(Pin-2) of the CPU to Active
or turn on the power again.
If it has been selected, the auto loading function will be enabled to
26
CBM-202PC-04 User's Manual
Resetting Method
CITIZEN
Advertisement
Table of Contents
